Auxiliary Heater Outlet and Inlet Line: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
1. Install new gasket seals and O-ring seals.
2. Add the correct amount of clean PAG oil to the refrigerant system. For additional information, REFER to REFRIGERANT OIL ADDING .
Fill the engine coolant level. For additional information, REFER to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
Evacuate, leak test and charge the refrigerant system. For additional information, REFER to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING or REFER to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .