Ignition Coil-On-Plug - LH: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the ignition coil-on-plug seals for rips, nicks or tears. Remove and discard any damaged ignition coil-on-plug seals.
- To install, slide the new ignition coil-on-plug seal onto the ignition coil-on-plug until it is fully seated at the top of the coil-on-plug.
-
NOTE: Apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.
Install the 3 LH ignition coil-on-plugs.
- Install the 3 LH
ignition coil-on-plug bolts.
- Tighten to 7 Nm (62 lb-in).
- Connect the 3 LH ignition coil-on-plug electrical connectors.