LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Automatic Transmission External Controls -Transmission Control Switch) >> Diagnosis And Testing >> External Controls >> Pinpoint Tests >> PINPOINT TEST C: TCS (Grade Assist) >> Pinpoint Test C: TCS (Grade Assist)

Pinpoint Test C: TCS (Grade Assist)

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. C1 RETRIEVE AND RECORD ALL DTCS 
    • Using the diagnostic scan tool, retrieve all DTSs  .

    Is DTC P1780 present? 

  2. C2 CHECK THE BCM FUSE 
    • Ignition OFF.
    • Remove the BCM  fuse 41 (7.5A).
    • Check BCM  fuse 41 (7.5A).

    Is the resistance less than 3 ohms? 

    • Yes  : GO to  C6.
    • No  : GO to C3  .
  3. C3 CHECK THE BCM FOR AN INTERNAL SHORT 
    • Disconnect: BCM C2280B  .
    • Inspect for damaged or pushed-out terminals.
    • Install a new fuse.

    Did the fuse fail? 

  4. C4 CHECK THE TCS POWER CIRCUIT FOR A SHORT TO GROUND 
    • Disconnect: Brake Shift Interlock C3245  .
    • Measure.
      Positive Lead Measurement/Action Negative Lead
      C3245-6  OHM Ground

    Is the resistance greater than 10, 000 ohms? 

    • Yes  : GO to C5  .
    • No  : REPAIR the circuit.
  5. C5 CHECK THE TCS SIGNAL INPUT CIRCUIT FOR A SHORT TO GROUND 
    • Disconnect: TCM C1750  .
    • Measure.
      Position Lead Measurement/Action Negative Lead
      C3245-5  OHM Ground

    Is the resistance greater than 10, 000 ohms? 

    • Yes  : GO to C6  .
    • No  : REPAIR the circuit.
  6. C6 CHECK THE TCS POWER CIRCUIT FOR AN OPEN 
    • Disconnect: Brake Shift Interlock C3245  .
    • Disconnect: BCM C2280B  .
    • Measure.
      Positive Lead Measurement/Action Negative Lead
      C3245-6  OHM C2280B-3 

    Is the resistance less than 3 ohms? 

    • Yes  : GO to C7  .
    • No  : REPAIR the circuit.
  7. C7 CHECK THE TCS SIGNAL INPUT CIRCUIT FOR AN OPEN 
    • Disconnect: TCM C1750  .
    • Measure.
      Positive Lead Measurement/Action Negative Lead
      C3245-5  OHM C1750-53 

    Is the resistance less than 3 ohms? 

    • Yes  : GO to C8  .
    • No  : REPAIR the circuit.
  8. C8 CHECK THE TCS 
    • Measure.
      Positive Lead Measurement/Action Negative Lead
      C3245-5  OHM C3245-6 

    Is the resistance less than 3 ohms with the switch pressed and greater than 10, 000 ohms when released? 

    • Yes  : INSTALL a new TCM  . PROGRAM the TCM  with the latest calibration level. PERFORM the Solenoid Body Strategy Download procedure. REFER to SOLENOID BODY STRATEGY DOWNLOAD .
    • No  : INSTALL a new selector lever knob. REFER to SELECTOR LEVER KNOB .