Receiver Drier Cartridge - 3.5L Ti-VCT, 3.7L Ti-VCT: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse the removal procedure.
- Lubricate the O-ring seal on the new receiver/drier plug with clean Polyalkylene Glycol (PAG) oil.
- Add the correct amount of clean Polyalkylene Glycol (PAG) oil to the refrigerant system. Refer to REFRIGERANT OIL ADDING .
- Evacuate, leak test and charge the refrigerant system. Refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .