LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 278 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender >> Removal

Removal And Installation: Fender: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headlamp assembly. REFER to HEADLAMP ASSEMBLY .
  2. Remove the cowl panel grille. Refer to COWL PANEL GRILLE .
  3. NOTE: RH shown in illustration, LH similar.

    Using a plastic trim removal tool, carefully remove the cowl panel grille filler panel beginning at the rear and working forward.

    G07431645
  4. Remove the fender splash shield. Refer to FENDER SPLASH SHIELD .
  5. NOTE: LH shown in illustration, RH similar.

    Remove the 2 fender-to-rocker panel bolts.

    G07431646
  6. NOTE: LH shown in illustration, RH similar.

    Remove the fender-to-A-pillar bolt.

    G07431647
  7. Remove the windshield applique. REFER to APPLIQUE - WINDSHIELD .
  8. NOTE: LH shown in illustration, RH similar.

    Remove the fender-to-cowl panel bolt.

    G07431648
  9. NOTE: LH shown in illustration, RH similar.

    Remove the 2 front fender-to-apron bolts.

    G07431649
  10. NOTE: LH shown in illustration, RH similar.

    Remove the 2 top fender-to-apron bolts.

    G07431650
  11. NOTE: LH shown in illustration, RH similar.

    Carefully cut the foam sealer between the fender, fender baffle and the A-pillar.

    G07431651
  12. Remove the fender.
scientia non olet · About LEMON Manuals