LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 278 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender >> Installation

Removal And Installation: Fender: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fender and A-pillar baffle to the vehicle.
  2. NOTE: LH shown in illustration, RH similar.

    Loosely install the 2 top fender-to-apron bolts.

    G07431650
  3. NOTE: LH shown in illustration, RH similar.

    Loosely install the 2 front fender-to-apron bolts.

    G07431649
  4. NOTE: LH shown in illustration, RH similar.

    Loosely install the fender-to-cowl bolt.

    G07431648
  5. NOTE: LH shown in illustration, RH similar.

    Loosely install the 2 fender-to-rocker panel bolts.

    G07431646
  6. Adjust the fender to specification. REFER to BODY REPAIRS , Component Description.
  7. NOTE: LH shown in illustration, RH similar.

    Apply flexible foam repair material to the fender, fender baffle and A-pillar seam.

    G07431651
  8. Tighten all fender fasteners.
    • Tighten all to 12 Nm (106 lb-in).
  9. Install the fender splash shield. Refer to FENDER SPLASH SHIELD .
  10. Install the windshield applique. REFER to APPLIQUE - WINDSHIELD .
  11. NOTE: RH shown in illustration, LH similar.

    Install the cowl panel grille filler panel.

    G07431645
  12. Install the cowl panel grille. Refer to COWL PANEL GRILLE .
scientia non olet · About LEMON Manuals