Pinpoint Test L: U0212:00

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

L1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
Is an observable symptom present?
1. Yes : GO to L2 .
2. No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
L2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a scan tool, perform a network test.
Does the SCCM pass the network test?
1. Yes : GO to L3 .
2. No : REFER to GO TO PINPOINT TEST G .
L3 RETRIEVE THE RECORDED DTCs FROM THE C-CM SELF-TEST
- Check for recorded DTCs from the C-CM self-test.
Is DTC U3003:16 or DTC U3003:17 recorded?
1. Yes : For the C-CM , GO to PINPOINT TEST Q or GO to PINPOINT TEST R .
2. No : GO to L4 .
L4 RECHECK THE C-CM DTCs
- Using a scan tool, clear the DTCs .
- Repeat the C-CM self-test.
Is DTC U0212:00 still present?
1. Yes : GO to L5 .
2. No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
L5 CHECK FOR DTC U0212:00 SET IN OTHER MODULES
- Clear all DTCs .
- Ignition OFF.
- Wait 10 seconds.
- Ignition ON.
- Retrieve the continuous memory DTCs from all modules.
Is DTC U0212:00 set in other modules?
1. Yes : INSTALL a new SCCM . REFER to STEERING COLUMN CONTROL MODULE (SCCM) .
2. No : INSTALL a new C-CM . Refer to CRUISE-CONTROL MODULE (C-CM) .