LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Four Wheel Drive (4WD) Systems) >> Removal And Installation >> All Terrain Control Module (ATCM) >> Removal

All Terrain Control Module (ATCM): Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the arm rest latch trim panel from the upper finish panel and position it aside.
  2. NOTE: It is not necessary to remove the upper finish panel to access the ATCM  retaining tabs.

    Remove the upper finish panel screw and lift the upper finish panel upward, releasing the rear retaining clips.

  3. Remove the ATCM  from the upper finish panel.
    1. Disconnect the ATCM  electrical connector.
    2. Press the ATCM  retaining tabs inward and remove the ATCM  from the upper finish panel.
scientia non olet · About LEMON Manuals