Seat Cushion Cover - 40 Percent: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, Refer to SEAT - EXPLODED VIEW .

Open the cushion cover.
1. Release the clip and separate the strut.
2. Separate the J-clips.
3. Separate the hook-and-loop strips.
  
  Fig 1: Identifying Strut Clip, Hook-And-Loop Strips And J-Clips
  Courtesy of FORD MOTOR CO.
From under the seat, pull the 4 cushion cover retainers (1 shown in illustration) out from between the cushion frame and riser.

Fig 2: Locating Cushion Cover Retainers
Courtesy of FORD MOTOR CO.
Detach the clips and remove the cushion cover from the cushion foam pad.
1. At installation, make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion cover and accessible for use after installation.