LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Handles, Locks, Latches And Entry Systems - With Intelligent Access) >> Removal And Installation >> Ignition Lock Cylinder Housing >> Removal

Ignition Lock Cylinder Housing: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with Premium Audio, remove the FCDIM  . REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM) .
  2. If equipped with Premium Plus Audio or SonySound, remove the Front Display Interface Module (FDIM). Premium Plus:  REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) or SonySound  REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) .
  3. Insert a non-marring tool between the ignition lock cylinder bezel and the instrument panel and pry outward.
    G07429428
  4. NOTE: Ignition lock cylinder housing shown from behind to show location of tab.

    Remove the ignition lock cylinder housing.

    • Push the tab to release the ignition lock cylinder housing.
    • Disconnect the 2 electrical connectors.
    G07429438
scientia non olet · About LEMON Manuals