LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Handles, Locks, Latches And Entry Systems - With Intelligent Access) >> General Procedures >> Autolock Programming >> Programming the Autolock Feature Using the Keyless Entry Keypad

Programming the Autolock Feature Using the Keyless Entry Keypad

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition to the OFF mode and close all vehicle doors.
  2. Enter the factory set 5-digit keyless entry keypad code.
  3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.
  4. Release the 7/8 button, then release the 3/4 button. The horn chirps once if autolock is disabled or twice (one short chirp followed by a honk) if autolock is enabled.
scientia non olet · About LEMON Manuals