Seat Backrest Thermo-Electric Device (TED): Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Install the backrest TED .
- Position the TED through the power lumbar cable.
- Attach the TED to the backrest foam pad wire.
- Engage the TED upper retainers to the backrest frame wire.
- Connect the electrical connector and attach the pin-type retainer.
Position the backrest cover downward, attach the hook-and-loop strips and engage the J-clip at the rear to the backrest frame wire.
Position the backrest cover downward, attach the hook-and-loop strips and install the 3 second row hog rings.
Position the backrest cover downward, attach the hook-and-loop strips and install the 3 first row hog rings.
Position the backrest cover downward and attach the hook-and-loop strips.
Route the wire harnesses through the backrest cover holes and engage the lower J-clips.
On each side of the seat backrest, attach the hook-and-loop strips.
Install the seat backrest. Refer to SEAT - EXPLODED VIEW, FRONT .