Lumbar Assembly - Power: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

if equipped, position the TED duct between the power lumbar and cable.

Fig 1: Locating TED Duct Between Power Lumbar And Cable
Courtesy of FORD MOTOR CO.
Install the power lumbar retaining clips to backrest frame and connect the power lumbar motor.

Fig 2: Locating Power Lumbar Retaining Clips
Courtesy of FORD MOTOR CO.
If equipped, connect the backrest TED electrical connector and engage the pin-type retainer.

Fig 3: Locating Pin Type Retainer
Courtesy of FORD MOTOR CO.
Position the backrest cover down and install new first row hog rings.
Roll the backrest cover down and attach the hook-and-loop strips.
Route the wire harnesses through the holes in the backrest cover and engage the lower J-clips.
Install the backrest cover hook-and-loop strips on each side of the backrest.
Install the seat backrest. Refer to SEAT BACKREST .