Dual Climate Controlled Seat Module (DCSM): Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the DCSM
in the following sequence.
- Connect the electrical connectors.
- Secure the locking wedges on the 2 DCSM electrical connectors.
- Position the DCSM and install the screws.
-
NOTE: This step is necessary only if the DCSM is being replaced.
PMI is required when installing a new DCSM . Refer to the scan tool instructions to carry out PMI .