Driver Seat Module (DSM): Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation.

NOTE: This step is necessary only if the DSM is being replaced.

PMI is required when installing a new DSM . Refer to the scan tool instructions to carry out PMI .
Position the front driver seat all the way back and up to access the DSM .
Remove the 2 screws.
Disconnect the electrical connectors and remove the Driver Seat Module (DSM).