LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Seat System - Seats-Seating - 1ST Row) >> Disassembly And Assembly >> Seat Backrest >> Assembly

Seat Backrest: Assembly

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the backrest frame assembly into the backrest foam pad.
  2. Install the 2 pin-type retainers.
  3. If equipped, install the power lumbar retaining clips to backrest frame and connect the power lumbar motor.
    Fig 1: Locating Power Lumbar Retaining Clips
    G06255705Courtesy of FORD MOTOR CO.
  4. If equipped, install the manual lumbar.
    • Engage the manual lumbar retainers.
    • Install the manual lumbar control cable retainer.
  5. If equipped, install the backrest TED  .
    • Position the TED  through the power lumbar cable.
    • Attach the TED  to the backrest foam pad wire.
    • Engage the TED  upper retainers to the backrest frame wire.
    • Connect the electrical connector and attach the pin-type retainer.
  6. If equipped, connect the backrest heater mat electrical connector and attach the pin-type retainer.
    Fig 2: Locating Backrest Heater Mat Electrical Connector
    G06063440Courtesy of FORD MOTOR CO.
  7. Install the seat backrest cover. Refer to SEAT BACKREST COVER .
scientia non olet · About LEMON Manuals