Output Shaft Seal - Slip Yoke: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Clean any debris from the extension housing that may have been left when the seal was removed.
Using the Output Shaft Seal Installer and the Drive Pinion Oil Seal Remover/Installer, install the output shaft seal.

Fig 1: Installing Output Shaft Seal Using Output Shaft Seal Installer And Drive Pinion Oil Seal Remover/Installer
Courtesy of FORD MOTOR CO.
Install the driveshaft. For additional information, refer to DRIVESHAFT .
Start the engine. Move the selector lever through all gear ranges while checking for engagements to allow the main control hydraulic circuits to fill with transmission fluid.
NOTE: The use of any transmission fluid other than specified may result in the transmission failing to operate in a normal manner or transmission failure.

Using the scan tool with the engine running, check and make sure the transmission is at normal operating temperature 82-93°C (180-200°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.