LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Automatic Transmission - 6R140 (TORQSHIFT-R-6)) >> Removal & Installation >> Extension Housing Gasket >> Removal

Extension Housing Gasket: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  2. Remove the transmission support insulator. For additional information, refer to TRANSMISSION SUPPORT INSULATOR .
  3. Remove the 8 extension housing bolts and the extension housing.
    Fig 1: Locating Extension Housing Bolts
    G07482776Courtesy of FORD MOTOR CO.
  4. Remove and discard the O-ring seal from the extension housing.
    Fig 2: Locating Extension Housing O-Ring Seal
    G07482777Courtesy of FORD MOTOR CO.
  5. Remove and discard the rear bushing fluid feed seal.
    Fig 3: Locating Rear Bushing Fluid Feed Seal
    G07482778Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals