LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Anti-Lock Brake System (Abs) And Stability Control) >> Diagnosis And Testing >> Anti-Lock Brake System (ABS) and Stability Control >> Pinpoint Tests >> Pinpoint Test I: U0140:00 >> Pinpoint Test I: U0140:00

Pinpoint Test I: U0140:00

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. I1 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Using a diagnostic scan tool, carry out the network test.

    Does the BCM pass the network test? 

    1. Yes  : GO to I2  .
    2. No  : REFER to GO TO PINPOINT TEST I .
  2. I2 CHECK THE ABS MODULE CMDTCs 
    • Using a diagnostic scan tool, carry out the ABS  module self-test.
    • Clear the DTCs  .
    • Ignition OFF.
    • Ignition ON.
    • Repeat the ABS  module self-test.
    • Record the ABS  module DTCs  .

    Is DTC U0140:00 retrieved again? 

    1. Yes  : GO to I3  .
    2. No  : The system is operating correctly at this time. The DTC  may have been set due to high network traffic or an intermittent fault condition.
  3. I3 REVIEW THE RECORDED DTCs FROM THE ABS MODULE SELF-TEST 
    • Check the recorded DTCs  from the ABS  module self-test.

    Is DTC U3003:16 or U3003:17 present? 

    1. Yes  : For DTC  U3003:16, GO to PINPOINT TEST A .

      For DTC  U3003:17, GO to PINPOINT TEST P .

    2. No  : GO to I4  .
  4. I4 CHECK FOR DTCs IN THE BCM 
    • Using a diagnostic scan tool, carry out the BCM  self-test.

    Is DTC U3003:16 or U3003:17 present? 

    1. Yes  : For DTC  U3003:16, REFER to GO TO PINPOINT TEST H .

      For DTC  U3003:17, REFER to GO TO PINPOINT TEST I .

    2. No  : GO to I5  .
  5. I5 CHECK FOR DTC U0140:00 SET IN OTHER MODULES 
    • Using a diagnostic scan tool, carry out the self-test for all modules.
    • Retrieve and record the CMDTCs  from all modules.

    Is DTC U0140:00 set in any other module? 

    1. Yes  : CHECK OASIS  for any applicable TSBs  . If a TSB  exists for this concern, discontinue this test and follow TSB  instructions. If no TSBs  address this concern, INSTALL a new BCM  . REFER to BODY CONTROL MODULE (BCM) - WITH INTELLIGENT ACCESS or REFER to BODY CONTROL MODULE (BCM) - WITHOUT INTELLIGENT ACCESS .
    2. No  : CHECK OASIS  for any applicable TSBs  . If a TSB  exists for this concern, DISCONTINUE this test and FOLLOW the TSB  instructions.

      If no TSBs  address this concern and the vehicle is not equipped with adaptive cruise control, INSTALL a new ABS  module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE .

      If no TSBs  address this concern and the vehicle is equipped with adaptive cruise control, INSTALL a new ABS  module and HCU  . REFER to HYDRAULIC CONTROL UNIT (HCU) .

scientia non olet · About LEMON Manuals