Solenoid Body Assembly: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Install a new solenoid body gasket.

Fig 1: Locating Solenoid Body Gasket
Courtesy of FORD MOTOR CO.
Using the Valve Body Aligner, install the solenoid body and loosely install the bolts.
- While installing the solenoid body, align the manual valve.
  
  Fig 2: Installing Solenoid Body Using Valve Body Aligner
  Courtesy of FORD MOTOR CO.
Tighten all the bolts in the sequence shown in illustration.
- Tighten to 13 Nm (115 lb-in).
  
  Fig 3: Identifying Solenoid Body Bolts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Connect the TR sensor connector.

Fig 4: Locating TR Sensor Connector
Courtesy of FORD MOTOR CO.
Install the transmission fluid filter, pan gasket and pan. For additional information, refer to FLUID PAN, GASKET AND FILTER .
Connect the transmission vehicle harness connector.
- Tighten to 5 Nm (44 lb-in).
  
  Fig 5: Locating Transmission Vehicle Harness Connector
  Courtesy of FORD MOTOR CO.