LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 5R110W (TORQSHIFT-R)) >> In-Vehicle Repair >> Internal Harness Service >> Removal

Internal Harness Service: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .
  2. Disconnect the transmission internal harness.
    1. Remove the 2 screws.
    2. Disconnect the Transmission Fluid Temperature (TFT) sensor.
    3. Disconnect the solenoid connectors.
      Fig 1: Identifying Transmission Fluid Temperature Sensor And Solenoid Connectors
      G06140695Courtesy of FORD MOTOR CO.
  3. Remove the transmission internal harness connector O-ring seal.
    Fig 2: Locating Transmission Internal Harness Connector O-Ring Seal
    G06140696Courtesy of FORD MOTOR CO.
  4. Lift the tab. Twisting the transmission internal harness connector, push it through the solenoid body and remove the wire harness.
scientia non olet · About LEMON Manuals