LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 5R110W (TORQSHIFT-R)) >> Diagnosis & Testing >> Transmission Drive Cycle Test >> Before Pinpoint Tests

Before Pinpoint Tests

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to starting pinpoint tests, check the PCM wiring harness for correct connections, bent or broken terminals, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION - DIESEL MODELS .
NOTE: If a concern still exists after electrical diagnosis has been carried out, refer to DIAGNOSIS BY SYMPTOM .

If DTCs appear while carrying out the On-Board Diagnostic (OBD) test, refer to DIAGNOSTIC TROUBLE CODE (DTC) CHARTS  for the appropriate procedure. Prior to starting pinpoint tests, refer to any TSBs for transmission concerns.

scientia non olet · About LEMON Manuals