Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The RDU does not have stub shaft pilot bearings. It has stub shaft seals only.

Remove the halfshaft assembly. REFER to HALFSHAFT .
Using the Torque Converter Fluid Seal Remover 307-309 T94P-77001-BH and Slide Hammer 100-001 T50T-100-A, remove and discard the stub shaft seal.

Fig 1: Removing Stub Shaft Seal Using Torque Converter Fluid Seal Remover

Courtesy of FORD MOTOR CO.