LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Anti-Theft System - Passive Anti-Theft System (Pats), With Intelligent Access) >> Removal And Installation >> Passive Start Antenna - Rear >> Removal

Passive Start Antenna - Rear: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position aside the liftgate weatherstrip.
  2. NOTE: To avoid damage to the liftgate scuff plate trim panel, remove any retaining clips from the body and attach them to the liftgate scuff plate trim panel before installing.

    Remove the liftgate scuff plate trim panel.

    1. Pull upward to release the retaining clips.
    2. Disconnect the rear passive start antenna electrical connector and remove the liftgate trim panel.
      G09090656
  3. Remove the 2 rear passive start antenna screws and remove the rear passive start antenna.
scientia non olet · About LEMON Manuals