Body Control Module (BCM) - Without Intelligent Access (IA) : Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Before beginning any service procedure, refer to SAFETY WARNINGS . Failure to follow this instruction may result in serious personal injury.

NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

NOTE: If installing a new module, all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

If installing a new module, upload the module configuration information from the BCM into the scan tool by following the scan tool on-screen instructions.
Remove the steering column cover trim panel. Refer to the exploded view in, INSTRUMENT PANEL AND CONSOLE .
Remove the driver side instrument panel insulator.
Remove the BCM .
1. Disconnect the electrical connectors.
2. Release the locking tab.
3. Move the BCM toward the rear of the vehicle.