Trailing Arm: Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE: Suspension fasteners are critical parts that affect performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Measure the distance from the center of the wheel hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
- Remove the wheel and tire. REFER to WHEEL AND TIRE .
- Use a jackstand to raise the rear suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken in Step 1 of the procedure (curb height).
- Remove and discard the trailing arm-to-knuckle nut and bolt.
- Remove and discard the trailing arm-to-subframe bolt and remove the trailing arm.