- No communication with the BCM
|
- Wiring, terminals or
- connectors
- BCM
|
|
- No communication with the RFA
module
|
- Wiring, terminals or connectors
- RFA
module
|
|
- No power in all ignition switch positions - vehicles with a conventional ignition switch
|
- Fuse
- Wiring, terminals or connectors
- Ignition switch
|
|
- No power in ACC - vehicles with a conventional ignition switch
|
- Fuse
- Wiring, terminals or connectors
- RUN/ACC relay
- BCM
|
|
- No power in ACC - vehicles with a push button start system
|
- Fuse
- Wiring, terminals or connectors
- RUN/ACC relay
- BCM
|
|
- No power in RUN - vehicles with a conventional ignition switch
|
- Fuse
- Wiring, terminals or connectors
- RUN/START relay
- Ignition switch
- BCM
|
|
- No power in RUN - vehicles with a push button start system
|
- Battery
- Fuse
- Wiring, terminals or connectors
- RUN/START relay
- Start/stop switch
- RKE
system
- PATS
- BCM
- RFA
module
|
|
- No power in START - vehicles with a conventional ignition switch
|
- Wiring, terminals or connectors
- Ignition switch
|
|
- No power in START - vehicles with a push button start system
|
- Battery
- Fuse
- Wiring, terminals or connectors
- RUN/START relay
- Start/stop switch
- Starting system
- RKE
system
- PATS
- BCM
- RFA
module
|
|
- NO KEY DETECTED is displayed in the message center
|
- Wiring, terminals or connectors
- Intelligent Access (IA) key
- RFA
module antennas
- RFA
module
|
|
- STARTING SYSTEM FAULT is displayed in the message center
|
- Wiring, terminals or connectors
- PATS
- RFA
module
|
|
- The ignition key cannot be returned to the OFF position
|
- Wiring, terminals or connectors
- Ignition lock cylinder
- Key removal inhibit solenoid (part of the ignition switch)
- Park range switch (part of the selector lever)
|
|
- The ignition key can be turned to the OFF position when the selector lever is not in PARK
|
- Wiring, terminals or connectors
- Key release interlock actuator (part of the ignition switch)
- Park range switch (part of the selector lever)
|
|
- The ignition key is hard to turn
|
- Ignition lock cylinder
- Ignition key
- Ignition switch
|
|
- The multifunction switch does not operate correctly
|
|
|
- The wiper/washer switch does not operate correctly
|
|
|
- The start/stop switch mode indicator is always/never illuminated
|
- Wiring, terminals or connectors
- Start/stop switch
- BCM
|
|