LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Exterior Lighting System) >> General Procedures >> Autolamps Time Delay Adjustment >> General Procedure

General Procedure

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Before beginning any service procedure, refer to SAFETY WARNINGS . Failure to follow this instruction may result in serious personal injury.
NOTE: The time delay can be programmed through the message center using the message center buttons (if equipped) or using the following steps.
NOTE: Steps  2 through  5 must be carried out within a 10-second period.
  1. Start with the ignition switch off and the headlamp switch in the AUTOLAMPS ON position.
  2. Place the headlamp switch in the OFF position.
  3. Place the ignition in RUN.
  4. Place the ignition in OFF.
  5. Place the headlamp switch in the AUTOLAMPS ON position. The exterior lamps turn on at this point.
  6. Wait the desired amount of time and place the headlamp switch in the OFF position (maximum of 3 minutes). The exterior lamps turn off and the autolamp time delay is now set.
scientia non olet · About LEMON Manuals