Trough Assembly: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:

the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
the roof opening panel glass has been removed from the roof opening panel system.
the roof opening panel assembly has been removed from the vehicle.
a new roof opening sliding glass or power shade motor has been installed.
a new roof opening panel glass has been installed.
a new roof opening panel assembly has been installed.

Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .

NOTE: Make sure that the springs are installed as shown in illustration before installation of the drain trough.

Fig 1: Identifying Spring Position
Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
- Check for correct alignment of the front sliding glass panel. Refer to ROOF OPENING PANEL ALIGNMENT - FRONT .
- Initialize the front sliding glass panel motor. Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL .