Roof Opening Panel Glass - Front Sliding: Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:
Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
- the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
- the roof opening panel glass has been removed from the roof opening panel system.
- the roof opening panel assembly has been removed from the vehicle.
- a new roof opening sliding glass or power shade motor has been installed.
- a new roof opening panel glass has been installed.
- a new roof opening panel assembly has been installed.
Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
- Position the front sliding glass panel to the CLOSED position and the power shade to the full OPEN position.
- Unclip the top portion of the concertina blind and slide the concertina blind rearward to access the sliding glass screws.
- Remove the 4 front sliding glass panel screws.
- From the outside of the vehicle, remove the front sliding glass panel assembly.