Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
NOTE: Use extreme care when removing the slinger or damage to the engine front cover may occur.

Using 2 pocket screwdrivers, carefully remove and discard the front crankshaft slinger.
- It will be necessary to remove the slinger from the sides as well as the top and bottom.
NOTE: Do not scratch or damage the crankshaft during removal or installation of the front crankshaft seal.

Using the Front Crank Seal Remover, remove and discard the front crankshaft seal from the engine front cover.

Fig 1: Removing Front Crankshaft Seal From Engine Front Cover Using Front Crank Seal Remover
Courtesy of FORD MOTOR CO.
Clean and inspect the crankshaft sealing surface.