LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical - 6.7L Diesel) >> General Procedures >> Powertrain/Drivetrain Mount Neutralizing

Powertrain/Drivetrain Mount Neutralizing

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Loosen, but do not remove, the engine support insulator nuts.
  3. Lower the vehicle.
  4. NOTE: Do not twist or strain the engine support insulators or damage to the engine support insulator may occur.

    Start the vehicle and move it in forward 0.6-1.2 m (2-4 ft). Then move the vehicle in reverse the same distance.

  5. Raise and support the vehicle.
  6. NOTE: Failure to replace the engine support insulator nuts may result in engine support insulator damage.
    NOTE: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulator may occur.
    NOTE: Refer to ENGINE SUPPORT INSULATORS  procedure for special instructions on tightening engine support insulator nuts.

    Remove and discard the engine support insulator nuts. Install new engine support insulator nuts.

  7. Lower the vehicle.
  8. Test the system for normal operation.
scientia non olet · About LEMON Manuals