Dust and Water Leaks
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
Most dust and water leaks occur due to missing or incorrectly installed body sealer or components. The source of the leak is detected by:
- pressurizing the vehicle and testing with soapy water.
- Locate and tape off the body vents.
- Turn the blower motor to HI.
- Turn the air recirculation OFF.
- Close the windows and doors.
- Open the hood and spray soapy water along body seams and grommets. Make sure to test the areas around the A-pillar at the fender and the hood hinge area.
- Check for bubbles.
- inspecting for a dust pattern or water path near and above the area in question.
- removing any trim or carpet in the general area of the leak.
- road testing or water-hose testing the vehicle.
- placing a bright light under the vehicle, removing any necessary trim or carpet and inspecting the interior of the body at joints and weld lines.