LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Brake System - General Information) >> Diagnosis And Testing >> Brake System >> Symptom Chart - NVH

Symptom Chart - NVH

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this service information assumes a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to DIAGNOSTIC METHODS for information about these practices.

SYMPTOM DESCRIPTION - NVH

Condition Possible Sources Action
NOTE: NVH symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, REFER to NOISE, VIBRATION & HARSHNESS . Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to REFER to NOISE, VIBRATION & HARSHNESS for the next likely system and continue diagnosis.
  • Vibration when the brakes are applied
  • Brake disc(s)
  • Suspension component(s)
  • Brake vibration/shudder - occurs when the brake pedal is released
  • Brake drag
  • Rattling noise
  • Caliper guide pins or guide pin bolts
  • Missing or damaged anti-rattle clips or springs
  • Loose brake disc shield
  • Squealing noise - occurs on first (morning) brake application
  • Brake pads
  • Acceptable condition. Caused by humidity and low brake pad temperature.
  • Squealing noise - a continuous squeal
  • Brake pads
  • Squealing noise - an intermittent squeal
  • Brake pads
  • Acceptable condition. Caused by cold, heat, water, mud or snow.
  • Groaning noise - occurs at low speeds with brake lightly applied (creeping)
  • Brake pads
  • Acceptable condition.
  • Grinding/moaning noise - continuous
  • Brake pads
  • Brake disc
  • INSPECT the brake pads, brake discs and attaching hardware for damage. VERIFY brake components are within specifications. REFER to BRAKE SYSTEM INSPECTION  in this section.