LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 6F50/6F55) >> Removal And Installation >> Solenoid Body Assembly >> Removal

Solenoid Body Assembly: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The PCM must be updated with a new solenoid body strategy data file and solenoid body identification anytime a new solenoid body is installed. A new solenoid body service tag must be installed over the current solenoid body service tag on top of the transmission case.
  1. With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING .
  2. Remove the main control cover. For 3.5L GTDI  refer to, MAIN CONTROL COVER - 3.5L GTDI . For 3.5L Ti-VCT  refer to, MAIN CONTROL COVER - 3.5L TI-VCT . For 3.7L Ti-VCT  refer to, MAIN CONTROL COVER - 3.7L TI-VCT .
  3. Slide the TR  sensor electrical connector lock tab over.
    G08412410
  4. G08412411
  5. G08412418
  6. NOTE: Handle the solenoid body with care or damage to the solenoid body may occur.
    G08412412
scientia non olet · About LEMON Manuals