LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - 6F35) >> Removal And Installation >> Transmission Case Bushing >> Removal

Transmission Case Bushing: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Before beginning any service procedure, refer to SAFETY WARNINGS . Failure to follow this instruction may result in serious personal injury.
  1. Remove the 4 retainers and the underbody shield.
    G08030917Courtesy of FORD MOTOR CO.
  2. Remove the front LH  halfshaft. Refer to HALFSHAFT SEAL - LH .
  3. NOTE: Leave the drain plug out after the transmission fluid drains. The drain plug will need to remain out to clean any debris from the damaged or worn bushing.

    Remove the drain plug and drain the transmission.

    G08030924Courtesy of FORD MOTOR CO.
  4. Install 205-D015 D80L-630-4 in the differential carrier.
    G08031089Courtesy of FORD MOTOR CO.
  5. Using 308-070 T77L-7697-E remove the LH  halfshaft bushing.
    G08031090Courtesy of FORD MOTOR CO.
  6. Remove 205-D015 D80L-630-4 from the differential carrier.
    G08031089Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals