LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Engine Mechanical -3.5L Ti-VCT) >> Removal And Installation >> Flexplate >> Installation

Removal And Installation: Flexplate: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

    Install the flexplate and the 8 bolts.

    • Tighten in the sequence shown in illustration to 80 Nm (59 lb-ft).
      G08621637
  2. Install the transaxle. REFER to TRANSMISSION - FRONT WHEEL DRIVE (FWD) or REFER to TRANSMISSION - ALL WHEEL DRIVE (AWD) .
  3. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals