Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different car, the 2013 Ford F-350 Super Duty and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil pressure and severe engine damage.

NOTE: Clean and inspect the mating surfaces and install a new O-ring. Lubricate the O-ring with clean engine oil prior to installation.

Position the oil pump screen and pickup tube and install the 2 front bolts.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 1: Locating Oil Pump Screen And Pickup Tube Bolts
  Courtesy of FORD MOTOR CO.
Install the oil pump screen and pickup tube support bracket nut.
- Tighten to 24 Nm (18 lb-ft).
  
  Fig 2: Locating Pickup Tube Support Bracket Nut
  Courtesy of FORD MOTOR CO.
Install the oil pan. For additional information, refer to OIL PAN .