LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Mechanical - 3.7L Ti-VCT) >> Removal And Installation >> Upper Intake Manifold >> Installation

Upper Intake Manifold: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new gasket, install the intake manifold and the 7 bolts.
    • Tighten in the sequence shown in illustration in 2 stages:
      • Stage 1: Tighten to 10 Nm (89 lb-in).
      • Stage 2: Tighten an additional 45 degrees.
        G08028885
  2. Install the upper intake manifold support bolt.
    • Tighten to 10 Nm (89 lb-in).
      G08028883
  3. Attach the 2 wiring harness/coolant tube retainers to the upper intake manifold.
    G09066232
  4. Connect the power brake booster vacuum supply hose and crankcase ventilation hose to the upper intake manifold.
    G07929437
  5. Connect the EVAP  vapor tube to the EVAP  canister purge valve. REFER to QUICK CONNECT COUPLING .
    • Attach the EVAP  vapor tube to the 2 retainers.
      G08028880
  6. Connect the EVAP  canister purge valve and throttle body electrical connectors.
    • Attach the wiring harness pin-type retainer.
      G08028879
  7. Install the ACL  outlet pipe. REFER to INTAKE AIR SYSTEM COMPONENTS - EXPLODED VIEW .
scientia non olet · About LEMON Manuals