LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Mechanical - 3.7L Ti-VCT) >> Removal And Installation >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan may cause engine failure.
  1. Install the oil pump and the 3 bolts.
    • Tighten to 10 Nm (89 lb-in).
      G08029483
  2. Using a new O-ring seal, install the oil pump screen and pickup tube and the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
      G08029482
  3. Install the crankshaft timing chain sprocket with timing dot mark out.
    G08029005
  4. NOTE: It may be necessary to rotate the camshafts slightly, to align the timing marks.

    Position the primary timing chain with the colored links aligned with the timing marks on the VCT assemblies and the crankshaft sprocket.

    G08029049
  5. Install the lower LH primary timing chain guide and the 2 bolts.
    G08029001
  6. Install the primary timing chain tensioner arm.
    G08029000
  7. Reset the primary timing chain tensioner.
    1. Release the ratchet detent.
    2. Using a soft-jawed vise, compress the ratchet plunger.
    3. Align the hole in the ratchet plunger with the hole in the tensioner housing.
    4. Install a suitable lockpin.
      G08029052
  8. NOTE: It may be necessary to rotate the camshafts slightly to remove slack from the timing chain to install the tensioner.

    Install the primary tensioner and the 2 bolts.

    • Tighten to 10 Nm (89 lb-in).
    • Remove the lockpin.
      G08029053
  9. As a post-check, verify correct alignment of all timing marks.
    • There are 48 links in between the RH intake VCT  assembly colored link (1) and the LH intake VCT assembly colored link (2).
    • There are 35 links in between LH intake VCT  assembly colored link (2) and the 2 crankshaft sprocket links (3).
      G07986724
  10. Remove the RH 303-1248.
    G08028995
  11. Install the RH valve train oil tube and the 3 bolts and tighten in 2 stages.
    • Stage 1: Tighten to 8 Nm (71 lb-in).
    • Stage 2: Tighten an additional 45 degrees.
      G08028994
  12. Remove the LH 303-1248.
    G08028993
  13. Install the Left Hand (LH) valve train oil tube and the 3 bolts and tighten in 2 stages.
    • Stage 1: Tighten to 8 Nm (71 lb-in).
    • Stage 2: Tighten an additional 45 degrees.
      G09066314
  14. Install the engine front cover. Refer to ENGINE FRONT COVER .
scientia non olet · About LEMON Manuals