LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (Climate Control System) >> Removal And Installation >> Heating Ventilation Air Conditioning (HVAC) Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Front Display Interface Module (FDIM). For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
  2. NOTE: Vehicles equipped with Electronic Automatic Temperature Control (EATC) have 2 HVAC module electrical connectors. Vehicles equipped with Electronic Manual Temperature Control (EMTC) have 1 HVAC module electrical connector.

    Disconnect the 2 HVAC module electrical connector(s).

  3. Release the HVAC module retaining clips and remove the HVAC module.
  4. NOTE: Be sure that all HVAC module electrical connectors are securely fastened before installing the center instrument panel finish panel.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals