Clutch and Clutch Field Coil: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Remove the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR - 3.7L or AIR CONDITIONING (A/C) COMPRESSOR - 5.0L AND 5.8L .
Remove the A/C clutch disc and hub bolt.
1. Using the A/C Clutch Holding Tool, hold the A/C clutch disc and hub.
2. Remove the A/C clutch disc and hub bolt.
  
  Fig 1: Removing A/C Clutch Disc And Hub Bolt
  Courtesy of FORD MOTOR CO.
Remove the A/C clutch disc and hub.
Remove the A/C clutch disc and hub spacer(s).
Remove the A/C compressor pulley snap ring.
NOTE: Do not use air tools. Damage to the Air Conditioning (A/C) clutch field coil or A/C compressor may result.

Remove the A/C compressor pulley.
1. Install the A/C compressor shaft protector.
2. Install a suitable 3-jaw puller on the A/C compressor shaft protector and A/C compressor pulley.
3. Remove the A/C compressor pulley.
  
  Fig 2: Removing A/C Compressor Pulley Using 3-Jaw Puller
  Courtesy of FORD MOTOR CO.
Remove the 3 A/C clutch field coil screws.
Detach the A/C clutch field coil electrical connector pin-type retainer and remove the A/C clutch field coil.