LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Transmission Cooling System (6R80)) >> Removal And Installation >> Transmission Fluid Cooler >> Installation

Transmission Fluid Cooler: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission fluid cooler into the retaining pockets.
    G07488486
  2. Install the 2 transmission fluid cooler screws.
    • Tighten to 9 Nm (80 lb-in).
      G07488485
  3. Install the transmission fluid cooler tube-to-fan shroud bolt.
    • Tighten to 8 Nm (71 lb-in).
      G07488484
  4. Connect the transmission cooler tube assemblies.
    G08644784
  5. Install both transmission fluid cooler tube quick connect secondary latches.
    G08644764
  6. Position the A/C condenser back and install the 2 nuts.
    • Tighten to 8 Nm (71 lb-in).
      G07488481
  7. Install the lower radiator sight shield and 13 screws.
    G07488444
  8. Position the underbody shield and install the 3 bolts.
    • Tighten to 10 Nm (89 lb-in).
      G07488443
  9. Install the 2 A/C condenser bolts.
    • Tighten to 10 Nm (89 lb-in).
      G07488478
  10. Install the upper radiator support brackets and 4 bolts.
    • Tighten to 10 Nm (89 lb-in).
      G07488477
  11. Connect the cooling fan electrical connector.
    G08644792
  12. Position the degas bottle and install the 2 bolts.
    G07488475
  13. Install the Air Cleaner (ACL) assembly, the ACL outlet pipe and the ACL inlet pipe. Refer to INTAKE AIR DISTRIBUTION & FILTERING .
  14. Install the upper air deflector and 8 pin-type retainers.
    G07488474
  15. Fill the transmission with fluid and verify correct operation. Refer to TRANSMISSION FLUID LEVEL CHECK .
scientia non olet · About LEMON Manuals