In-Vehicle Repair: Flywheel: Removal
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the clutch. For additional information, refer to CLUTCH .
- Remove the 8 flywheel bolts.
-
NOTE: The flywheel is a press fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to the flywheel or engine may occur.
Remove the flywheel.
- Install 2 of the removed flywheel bolts in the 2 holes shown in illustration on the flywheel flange.
- Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.