Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

Remove the brake pedal and bracket assembly. For additional information, refer to HYDRAULIC BRAKE ACTUATION .
Remove the retaining clip from the clutch pedal pin.
Remove the 2 clutch master cylinder bolts, then disconnect the clutch master cylinder from the clutch pedal.
- To install, tighten to 10 Nm (89 lb-in).
Remove the reservoir hose from the clutch master cylinder.
NOTE: Install new hose clamps on the reservoir hose.
To install, reverse the removal procedure.
Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
Check the clutch for normal operation.