LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 8 pin-type retainers and the upper radiator sight shield.
  2. NOTE: Mark the location of the hood latch to aid installation.

    Remove the 2 hood latch bolts.

    • To install, tighten to 12 Nm (106 lb-in).
  3. Disconnect the hood latch release cable.
  4. Remove the hood latch.
  5. To install, reverse the removal procedure.
    • Adjust the hood latch for correct engagement after installation.
scientia non olet · About LEMON Manuals