Passenger Airbag: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Install the passenger air bag module.
- Seat the air bag trim cover clips into the instrument panel.
Connect the passenger air bag module electrical connector.
Install the 2 passenger air bag module bolts.
- Tighten to 11 Nm (97 lb-in).
Position the APIM and install the 4 bolts.

Fig 1: Locating Accessory Protocol Interface Module And Mounting Bolts
Courtesy of FORD MOTOR CO.
Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion.