Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.

WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

Using a suitable tool, remove the brake fluid from the brake fluid reservoir.
If equipped with a manual transmission, release the clamp and disconnect the clutch hose from the brake fluid reservoir.
Remove the brake fluid reservoir pin.
- To install, tighten to 8 Nm (71 lb-in).
NOTE: Use new seals provided with a new brake fluid reservoir.

Remove the brake fluid reservoir.
- When installing the brake fluid reservoir, lubricate the new seals with brake fluid.
To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION .
- If equipped with a manual transmission, bleed the clutch master cylinder. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION for Clutch System Bleeding.