Bumper Cover - Front, 5.0L: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

All Vehicles

With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
To install, tighten to 5.4 Nm (48 lb-in).
Three on each side.
- To install, tighten to 3 Nm (27 lb-in).
GT vehicles
To install, tighten to 1.9 Nm (17 lb-in).

Boss 302, California Special and Laguna Vehicles
To install, tighten to 1.3 Nm (12 lb-in).

All Vehicles
On each side.
If required.
- To install, tighten to 2.2 Nm (19 lb-in).