LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Bumper System) >> Removal And Installation >> Bumper - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper cover. Refer to BUMPER COVER - FRONT, 3.7L , BUMPER COVER - FRONT, 5.0L  or BUMPER COVER - FRONT, GT500 .
  2. Remove the 4 front bumper isolator pin-type retainers and the front bumper lower outer and upper center inner isolators.
  3. Drill out the 6 front bumper spot welds.
  4. Remove the 8 front bumper bolts and the front bumper.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. NOTE: Spot welding the bumper is not required for installation.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals